Tuesday, September 27, 2011


Emco turret controller for Mach
  • For Turn 120, 120P, 220, Compact 6 lathes (possibly also mills)
  • Use your existing tool changer seamlessly with Mach 3
  • Current control and 'lock' sensing pauses execution until toolchange is complete
  • Four additional relay drivers (power chuck, coolant pump, etc.) on board
  • Full electrical isolation
  • Includes all necessary drivers/macros
  • Requires 24V linear power supply, 3A minimum
Currently under test with Mach 3 via built-in Modbus. 
Additional units will be made available for sale once testing is complete.
Posted by at

7 comments:

  1. juandresJanuary 24, 2012 at 7:16 PM

    Where can I buy that?

    ReplyDelete
    Replies
    1. AndrewMarch 8, 2012 at 2:41 AM

      Come back to this page and leave your email address in the form if you want one of the first few available.

      Delete
    2. UnknownOctober 7, 2016 at 9:04 AM

      Hello,
      It is now Oct 7, 2016 so wondering if this controller board is available?
      Thanks
      Rob Little
      Purcellville, VA
      robelittle@comcast.net

      Delete
  2. UnknownMay 9, 2017 at 5:14 AM

    hi
    need one for my emcoturn 120p too
    ASAP
    Tony, Denmark
    tonyschalburg@yahoo.dk

    ReplyDelete
  3. Benscale160March 22, 2018 at 6:41 AM

    If they are still available, I'm looking for one too.

    benscale160@yahoo.com

    Thanks
    Ben

    ReplyDelete
  4. AnttiJuly 22, 2018 at 8:58 AM

    Hi!

    Does this work with Emco Compact 5 turret? If so, I'm interested. My email is akrspam1@yahoo.com.

    Thanks,
    Antti

    ReplyDelete
  5. UnknownMay 4, 2019 at 7:33 AM

    Hi, I'd like to buy one sharp@area3design.com

    ReplyDelete

Subscribe to: Post Comments (Atom)